Take A 1 To 2 Inches (2.5 To 5.1 Cm) Section Of Hair From The New Layer.
First of all, to be calm, cut not more than an inch in 1 step, and keep hair straight before cutting (you may even flat iron it). Put another rubber a few inches below the first one. Continue shaving vertical sections up to the guideline until there is no hair below the guideline.
“Section Off A Triangular Section Across Your Forehead.
Then tie up the right side of your hair. Brush your hair again and tie another elastic band at the point where you want to cut your hair. Measure off the hair accordingly and hold the hair straight in between your fingers.
Take A 1 Cm Section Of Hair From The Right And Bring It To The Left.
Pull this section straight up. After you've finished trimming one layer of your hair, make sure the ends match up. Start by pulling your hair into a clean and neat ponytail at the back of your head, it needs to sit as tight as you can get it at the bottom of.
Keeping Your Fingers Parallel, Cut Straight Across, And Then Up.
Easy step by step tutorial on how to trim your lo. Pull your fingers down the hair at exactly the same pace. Add a thin strand from the bottom layer to it.
Starting From The Part, Create A 2 Cm Section On The Left Side.
Then, secure it with a rubber band. One of the possible ways to lighten the look is to make a few vertical snips into your hair. You don’t need to cut into the hair very much, even a few millimeters will soften the edges.
